Switch Cisco Catalyst 5002

Switch Cisco Cat 5002
  • Item: 13105
  • Marca: Cisco
  • Producto: Usado

Precio:  $450.00

Consultar

 

Switch Catalyst 5002

CatOs Version: 2.4 ( 5 )

Memoria RAm: 4Mb

2 Modulos Instalados:

1- Supervisor Engine

2- 24 Puertos 10/100 Base-TX

WS-C5002 Software, Version McpSW: 2.4(5) NmpSW: 2.4(5)
Copyright (c) 1995-1997 by Cisco Systems
NMP S/W compiled on May  7 1998, 11:34:14
MCP S/W compiled on May 07 1998, 11:37:31

System Bootstrap Version: 2.2(2)

Hardware Version: 2.3  Model: WS-C5002  Serial #: 002663565

Module Ports Model      Serial #  Hw     Fw      Fw1     Sw
------ ----- ---------- --------- ------ ------- ------- --------------------
1      2     WS-X5009   002663565 2.3    2.2(2)  2.2(1)  2.4(5)
2      24    WS-X5224   008157826 1.3    3.1(1)          0.0

Module DRAM    FLASH   NVRAM   Used    Available
------ ------- ------- ------- ------- ---------
1        8192K   4096K    256K     83K      173K

 

 

 

Explanation in Detail
In general, Cisco switches’ models are started with WS-. WS-C means the switch products and the products with WS-X begining refer to the engines or modules of switches. In addition, there is WS-G which means the Gigabit fiber optic transceiver modules of switches. Now, I explain the detailed meaning of each letter in the model through a few of examples.
eg. WS-C3560G-24TS-S

  • W — stands for IPSEC 40bit encryption;
  • S — means switchboard;
  • C — means the fixed-configuration switch;
  • 3650 — refers to the seires;
  • G — means all the interfaces are supported Gigabit or more. If there is no letter “G” here, it shows that the mainly port of this switch is 10/100M or 100M;
  • 24 — here means there are 24 ports of this switch;
  • T — stands for port of BaseT port; sometimes, there is letter “P” here which means BaseT port which supports PoE at the same time;
  • S — the S behind T means the extended interface is SFP type interface and uplink;

Note: There are also “D” or “C” or “W”repalcing “T” or “S” here, which respectively means 10Gigabit Ethernet XENPAK port and uplink, T/SPF and uplink, Integrated wireless LAN controller(50 support for up to 50 access points). Some combination meaning as following:
TT — common port and uplink port are both BaseT;
LC — common port is BaseT and partially support PoE(4 ports) uplink port are BaseT/SFP;
PC — common port is BaseT and all support PoE(24 ports) uplink port are BaseT/SFP;
TC –common port is BaseT and uplink port are all BaseT/SFP;
TS — common port is BaseT and uplink port are all SFP;
PS — common port is BaseT and all support the PoE, uplink port are all SFP;
FS — common port is 100BaseFX and uplink port are all SFP;
when there is only T, it means there is no uplink port in the switch.



Comentarios